MindWare & BioLab

<< Click to Display Table of Contents >>

Navigation:  Introduction to VideoSyncPro Studio > Third-Party Sensor Data Equipment >

MindWare & BioLab

MindWare Logo

MindWare Technologies provides hardware and software solutions for psychology, psycho-physiology, and broader life science research. They provide recorders and sensors to observe the full spectrum of autonomic nervous system responses, concentrating on Parasympathetic as well as Sympathetic measures. They offer mobile and stationary solutions for measuring:

oHeart Rate Variability (RSA, RMSSD)

oCardiac Impedance (PEP, LVET, Cardiac Output)

oSkin Conductance (SCL, EDA)

oBlood Pressure Variability (BPV)

oMuscle activity (EMG)

oPhotoplethysmography (PPG, Pulse Transit Time)

oRespiration 

oMotion/Activity 

MindWare's analysis software includes a broad range of analysis routines for the different types of data.

There is a close collaboration between Mangold International and MindWare, providing a scalable integrated solution for researchers that want to combine physiological data with simultaneous video recordings.

There is even a special 'recording only' edition of VideoSyncPro Studio, developed especially for MindWare users who want to record multiple cameras in sync with the BioLab data acquisition software.

MindWare has integrated a solution that controls Mangold VideoSyncPro Studio, allowing you to start and stop all recordings with a single command from within MindWare's BioLab software.

Configure MindWare intergration

The basic configuration of the VideoSyncPro Studio MindWare edition and how to integrate VideoSyncPro Studio in Biolab is described in detail in the Knowledge Base from MindWare in the article KB0093.
For wireless integration of MindWare sensor devices, use an AC-type advised by MindWare!

oFor wired connections, plug a cable into one of the free slots on the network switch.

oWireless connections require a small WiFi Access point like this:

Include an access point in the camera network:

Connect a LAN cable between the camera network switch and a WiFi Access point.

If the device is new, name it something like 'MangoldVideoLab' and provide a memorable password (like M@ngold)

Connect your wireless devices to this MangoldVideoLab WiFi network.

VSP_WiFiAccespoint

Example: TP-LINK TL-WR802N

TIP:In case or changing WiFi-devices, make sure this AC has and intergrated DHCP server to supply these devices with a fitting IP-number.